Header

Header
1983 Porsche 911 SC Targa

Friday, January 13, 2012

Keys, Locks, and Doors





For Christmas I received a Bentley repair manual. Perfect. This will come in handy.

To replace the worn out duplicate keys that came when I purchased the car, I ordered a couple of factory key blanks from Pelican Parts. At $58 each they are pricey, but a lot cheaper than getting them done at the dealer. They look great. A local locksmith was able to read the key code from my worn key, to make a proper cut instead of just making a copy of a worn out key. They also re-pinned the locks in the door handle to match the ignition switch. I am down to one key for operating all of the locks on the Porsche.
 





The new Porsche key blank looks good.  The difference between the worn out and newly cut key is dramatic.


The interior door trim and panels had to come apart to remove the door locks for the locksmith. As long as I’m in there, I might as well fix a few problems. The stock interior door handles are shockingly thin and flimsy plastic. I’m amazed they managed to last 30 years. I’m replacing them with black anodized aluminum handles.

After market anodized aluminium interior handles on the left.
Flimsy plastic stock door handles on the right.

The door panels have damage from what appears to be an old speaker installation. I can only get affordable replacement panels in black, but much of the door trim, the dash, and rear deck are black. I think it looks good.

Original door panels.

Replacement door panels.

Friday, January 6, 2012

Electric Motor

Component selection is something I’ve thought about a lot over the years. The goal is to select a combination of parts that will work well as a system. One of the key goals for me is to maintain performance that is comparable to the original. In 1983, this car would do zero to 60 mph (96.6 km/hr) in 7 seconds. This may seem tame by today’s standard, but it is plenty quick for me. The electric motor will be key to meeting this goal. Once the motor is installed, I will have a better idea of how much space is available for other components, especially where all 56 of the batteries are going to live.

Today I placed the order for an electric motor and adaptor kit. The electric motor is called the WarP9 from NetGain. It is just over 9 inches (235 mm) in diameter and 16 inches (400 mm) in length. It weighs 156 lbs (71 kg). It delivers 32 horsepower. That may not sound impressive, but it is a continuous output rating. In short bursts, the motor is capable of coming close to the stock gas engine output of 170 horsepower. A key advantage of an electric motor is that virtually all 200 ft lbs (270 Nm) of torque are available at 0 RPM, where a gas engine develops maximum power above 5000 RPM.

The adapter plate is a chunk of metal, typically aluminum, which mechanically fastens the motor to the transmission. It must be machined to tight tolerances to align the motor shaft and transmission shaft so that they spin along the same axis. A hub clamps onto the motor shaft and provides a means of attaching the flywheel. The clutch mounts to the flywheel the same as it did with the gas engine. Some people choose to go without a clutch and couple the motor and transmission rigidly. Going without the clutch has the advantage of less rotating mass and it’s much simpler mechanically. However, I think the driving experience will be better with the clutch.